- Metal gear rising revengeance costumes how to#
- Metal gear rising revengeance costumes mod#
- Metal gear rising revengeance costumes download#
I used a heat gun to pass over the foam until there is a slight glimmer/sparkle on the foam.I have experimented with a few methods that I have researched through google and (user DocHolliday has a lot of good methods) and this has produced good results from me. In order to paint foam, it needs to be properly sealed or else paint will seep through the pores of the foam and will not be smooth. Bulldog Adhesion Promoter (Pricey but an excellent brand that adds some flex).
Metal gear rising revengeance costumes mod#
Metal gear rising revengeance costumes how to#
One of the biggest challenges when making foam armor is how to seal and paint it so it actually looks like armor and not "foam with paint thrown on it." - Materials I used for this stage: This was my first trying to sculpt foam so I practice multiple times on scrap pieces of foam prior to sculpting the final piece. For the rib muscles, I used a Dremel with a flex shaft attachment and various sanding wheels slowly shaved and engraved the foam till I felt the shape looked right.For the muscle pieces, I used a sharp pencil to engrave the fiber lines into the foam.I glued the detail pieces that ended up black before painting.Next I would use my dremel with the grinding stone bit to clean up the inside of the drill marks.I would then drill through these markings with the appropriate sized bit In the previous step, I marked out holes in the foam from the pattern.Some of them I glued after painting, some before painting. I used over 200+ little grommets and disks to capture all the minute details. Dremel (The Dremel 4000 worked very well for me).So, if you try these techniques and you are unhappy with how your pattern turned out, then redo it! No biggy! I assume you cosplay for fun just like me, so we're not pros or anything! Bad patterns will result in a bad end product. 6) I then cut out the pattern with an Xacto knife - I used these same techniques for every section, including the props such as the sword and holster.Again, I want to reiterate patterning is a VERY IMPORTANT step in making your armor. I am really bad at drawing so it took a few tries till I felt “eh, good enough.” I also made sure to cut out holes for the 200+ grommet holes that would need to be filled later. 5) Within the boarders of the box I just drew, I would freehand sketch the part I was trying to make. If the cardstock was too small, I taped sheets together with scotch tape to make a bigger sheet. Example: Bicep_center_length = (My_Height (in cm) x Raiden_Photo_Height)/(Raiden_bicep center_length) Bicep_center_width = (My_Height x Raiden_Photo_Height)/(Raiden_bicep center_width) 4) Once I had a width/height estimate of each section of the piece, I drew a box with those dimensions on cardstock. Since this piece is symmetrical, I would just need to pattern the center and left side (then flip it over to use as the right side) 3) In order to scale my pieces properly in real life, I would measure the total height of Raiden on the photo, take measurements (in centimeters) of the part I wanted to make, then use a simple formula with my height to get the approximate scale for real life. For example, the bicep looks like it can be split into 3 main sections: 2) I would then choose a piece that I wanted to make and then envisioned how many pieces I would need to make the part.
Metal gear rising revengeance costumes download#
0 kommentar(er)
